The condenser is a suspended support, which can be used together with other equipment such as condenser, pipeline, storage tank, etc. In terms of structure, the condenser has compact structure, small floor area and easy installation and maintenance. The cooling tower device is omitted in the design of condenser and reaction kettle, which makes the equipment more integrated, reduces the construction difficulty, and is convenient for installation and daily maintenance. On the other hand, the unique structural design also reduces the floor area of the equipment. The latent heat exchange method not only improves the heat exchange efficiency, but also saves the water required for the operation of the equipment. However, the structural integration of the condenser not only reduces the transmission link of cooling water from the cooling tower to the condenser and saves the water consumption of circulating water, but also effectively reduces the output power of the water pump, so as to achieve the effect of energy conservation and consumption reduction. The equipment operation eliminates the cooling tower and avoids the water treatment problem caused by a large amount of water consumption, which, together with water conservation and energy conservation, constitutes a factor of operating cost saving. It is applied to the waste heat recovery application system. On the one hand, because of its advantages of energy conservation, environmental protection and low operating cost, it meets the strategic needs of sustainable economic development of enterprises. On the other hand, it is also in line with the current national policy requirements for environmental protection and energy conservation, which can not only be regarded as a breakthrough in the field of refrigeration and heat exchange, but also an environmental refrigeration innovation worthy of promotion.

The finned tubes of the condenser of the double-layer glass reactor shall be comprehensively cleaned and sorted to ensure that they are clean and arranged neatly. The condenser shall be comprehensively checked to see whether it is intact and whether it can work normally. If there is any problem, it shall be handled in time. If the heat dissipation of the condenser is not enough, it indicates that there is a problem. At this time, it is necessary to check whether the condenser matches the main engine. If it does not match, it should be handled in time. In addition, we can also flush the condenser fins with water, but this cannot be used for a long time, because it is easy to cause scale on the condenser fins over time, which will affect its heat exchange capacity and effect. The condenser can also be cleaned, but acidic cleaning agents should not be used, but alkaline ones should be used, so that the purpose of cleaning can be achieved.